UEE Series
Isolated, High-Density, Eighth-Brick
DOSA Low Pro?le DC-DC Converters
+VIN
+VOUT
+SENSE
+VCC
ON/OFF
CONTROL
TRIM
R TRIM DOWN
LOAD
ON/OFF
CONTROL
–SENSE
-VIN
–VIN
–VOUT
Figure 12. Trim Connections To Decrease Output Voltages
Remote On/Off Control
On the input side, a remote On/Off Control can be speci?ed with either positive
or negative logic logic.
Positive : Models equipped with positive logic are enabled when the On/Off
pin is left open or is pulled high to +Vin with respect to –Vin. An internal bias
current causes the open pin to rise to approximately +13.5V. Some models will
also turn on at lower intermediate voltages (see Speci?cations). Positive-logic
devices are disabled when the On/Off is grounded or brought to within a low
voltage (see Speci?cations) with respect to –Vin.
Negative : Models with negative logic are on (enabled) when the On/Off is
grounded or brought to within a low voltage (see Speci?cations) with respect to
Figure 13. Driving the On/Off Control Pin (suggested circuit)
Output Capacitive Load
These converters do not require external capacitance added to achieve rated
speci?cations. Users should only consider adding capacitance to reduce switch-
ing noise and/or to handle spike current step loads. Install only enough capaci-
tance to achieve noise objectives. Excess external capacitance may cause
regulation problems, slower transient response and possible instability. Proper
wiring of the Sense inputs will improve these factors under capacitive load.
The maximum rated output capacitance and ESR speci?cation is given for a
capacitor installed immediately adjacent to the converter. Any extended output
wiring or smaller wire gauge or less ground plane may tolerate somewhat higher
capacitance. Also, capacitors with higher ESR may use a larger capacitance.
–Vin. The device is off (disabled) when the On/Off is left open or is pulled high
to approximately +13.5V with respect to –Vin.
Dynamic control of the On/Off function should be able to sink the speci-
?ed signal current when brought low and withstand appropriate voltage
when brought high. Be aware too that there is a ?nite time in milliseconds
(see Speci?cations) between the time of On/Off Control activation and stable,
regulated output. This time will vary slightly with output load type and current
and input conditions.
www.murata-ps.com/support
MDC_UEE_Series.C01 Page 28 of 29
相关PDF资料
UEI15-050-Q12P-C CONV DC/DC 15W 5V 3A
UEI25-120-D48PM-C 36-75VIN 12VOUT 25W POS LOG SMD
UEI30-050-Q48N-C CONVERT DC/DC 30W 5V SNGL NEG
UEP1H470MPD CAP ALUM 47UF 50V 20% RADIAL
UES1V100MEM CAP ALUM 10UF 35V 20% RADIAL
UFG1V470MEM CAP ALUM 47UF 35V 20% RADIAL
UHD1A332MHD CAP ALUM 3300UF 10V 20% RADIAL
UHM0J102MPD3 CAP ALUM 1000UF 6.3V 20% RADIAL
相关代理商/技术参数
UEE-3.3/30-D48P-C 功能描述:DC/DC转换器 99W 3.3V 30A Pos Polarity TH RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压(标称): 输出端数量:1 输出电压(通道 1):3.3 V 输出电流(通道 1):600 mA 输出电压(通道 2): 输出电流(通道 2): 安装风格:SMD/SMT 封装 / 箱体尺寸:
UEE-3.3/30-D48PM-C 功能描述:DC/DC转换器 99W 3.3V 30A Pos Polarity SMT RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压(标称): 输出端数量:1 输出电压(通道 1):3.3 V 输出电流(通道 1):600 mA 输出电压(通道 2): 输出电流(通道 2): 安装风格:SMD/SMT 封装 / 箱体尺寸:
UEE-3.3/45-D48NB-C 功能描述:DC/DC CONVERTER 3.3V 150W 制造商:murata power solutions inc. 系列:UEE 150W 包装:托盘 零件状态:有效 类型:隔离模块 输出数:1 电压 - 输入(最小值):36V 电压 - 输入(最大值):75V 电压 - 输出 1:3.3V 电压 - 输出 2:- 电压 - 输出 3:- 电流 - 输出(最大值):45.5A 功率(W) - 制造系列:150W 电压 - 隔离:2.25kV(2250V) 应用:ITE(商业) 特性:远程开/关,OCP,OTP,SCP,UVLO 安装类型:通孔 封装/外壳:8-DIP 模块,1/8 砖 大小/尺寸:2.30" 长 x 0.90" 宽 x 0.50" 高(58.4mm x 22.9mm x 12.7mm) 工作温度:-40°C ~ 85°C 效率:92% 功率(W) - 最大值:150W 标准包装:21
UEE-3.3-15-D48 制造商:MURATA 制造商全称:Murata Manufacturing Co., Ltd. 功能描述:Isolated, High-Density, Eighth-Brick DOSA Low Profi le DC/DC Converters
UEE-3.3-25-D48 制造商:MURATA 制造商全称:Murata Manufacturing Co., Ltd. 功能描述:Isolated, High-Density, Eighth-Brick DOSA Low Profi le DC/DC Converters
UEE-3.3-30-D48 制造商:MURATA 制造商全称:Murata Manufacturing Co., Ltd. 功能描述:Isolated, High-Density, Eighth-Brick DOSA Low Profi le DC/DC Converters
UEE-5/30-D48NB-C 功能描述:DC/DC CONVERTER 5V 150W 制造商:murata power solutions inc. 系列:UEE 150W 包装:托盘 零件状态:有效 类型:隔离模块 输出数:1 电压 - 输入(最小值):36V 电压 - 输入(最大值):75V 电压 - 输出 1:5V 电压 - 输出 2:- 电压 - 输出 3:- 电流 - 输出(最大值):30A 功率(W) - 制造系列:150W 电压 - 隔离:2.25kV(2250V) 应用:ITE(商业) 特性:远程开/关,OCP,OTP,SCP,UVLO 安装类型:通孔 封装/外壳:8-DIP 模块,1/8 砖 大小/尺寸:2.30" 长 x 0.90" 宽 x 0.50" 高(58.4mm x 22.9mm x 12.7mm) 工作温度:-40°C ~ 85°C 效率:92% 功率(W) - 最大值:150W 标准包装:21
UEF-AUTOESL-25 制造商:Xilinx 功能描述:UNIVERSITY AUTOESL, 25 LICENSE BUNDLE - Virtual or Non-Physical Inventory (Software & Literature) 制造商:Xilinx 功能描述:AUTOESL 25 LICENSE BUNDLE